Shreveport Mold Pros logo Shreveport Mold Pros

Mold Remediation

Crawl Space Mold Removal in Shreveport, LA

Crawl space mold removal in Shreveport, LA — source moisture correction, vapor barrier repair and encapsulation for pier-and-beam homes where damp Caddo Parish soil keeps reseeding the floor above.

  • ✓Shreveport Based
  • ✓Mon–Sat 7:00 AM – 7:00 PM
  • ✓Caddo & Bossier Parish

Crawl space mold in Shreveport is almost never a cleaning problem. It is a moisture problem wearing a cleaning problem's clothes. Caddo Parish sits on flat terrain with a high water table and heavy clay soil that drains slowly, and a large share of the housing stock here is pier-and-beam construction built before modern vapor barriers were standard. Under those homes the soil stays damp year-round, the air beneath the floor sits near saturation through the summer, and the joists and subfloor above it stay at a moisture content mold is perfectly happy with. Scrub the growth off and leave the soil exposed, and it comes back within a season.

Why Shreveport Crawl Spaces Grow Mold Year-Round

Most of the country gets a dry season that resets crawl space humidity. Shreveport does not. The humid subtropical climate holds relative humidity high even through mild winters, and the stack effect pulls that damp air up through the floor into the living space rather than out of the house. Vented crawl spaces make it worse in this climate, not better: on a humid August afternoon, opening a vent invites 90-degree air at high humidity into a crawl space sitting at 68 degrees, where it condenses directly onto the joists.

The pattern is recognizable from inside the house. Cupping hardwood, a musty smell that is strongest in the morning, cold floors, and allergy symptoms that improve when the family leaves for a week all point downward. Roughly half of the air on a home's first floor has passed through the crawl space, so a contaminated crawl space is an indoor air quality problem for the whole house, not an isolated one under it.

Removal, Then the Part That Actually Matters

Physical removal is the straightforward half: HEPA containment, removal of colonized porous material — fiberglass batt insulation that has absorbed moisture almost never survives — HEPA vacuuming, controlled abrasive cleaning of framing where growth has penetrated the wood surface, and an antimicrobial application after the physical removal rather than instead of it. Treating wood without removing growth first is cosmetic.

The half that decides whether the work holds is moisture correction. That means grading and drainage at the perimeter so surface water stops running toward the foundation, a sealed vapor barrier across the soil rather than the torn sheeting most Shreveport crawl spaces actually have, sealing the vents, and in most cases a dedicated dehumidifier to hold the space under 60% relative humidity. Done properly, that is encapsulation, and in this climate it is the difference between a repair and a recurring bill.

Structural Damage Found Along the Way

Crawl space inspections in older Shreveport neighborhoods routinely turn up more than mold. Sill plates and joist ends soft enough to take a screwdriver, subfloor delamination under bathrooms, and rusted pier shims are common in homes in Allendale, Queensborough, and Cedar Grove where the crawl space has been damp for decades. Wood-destroying organisms follow sustained moisture, so a crawl space with established mold frequently has a termite or fungal decay history alongside it.

This matters for budgeting. The mold remediation line item is usually the smaller number. Replacing a run of joists or a section of subfloor is carpentry, priced separately, and worth knowing about before the work starts rather than halfway through.

Related Work

A damp crawl space rarely stays a crawl space problem. Because roughly half the air on the first floor has passed through it, contamination below the floor frequently shows up as HVAC and air duct mold once the system starts drawing from that space, and as growth on the backs of closet and exterior walls above it. If the space under your house is a below-grade finished or concrete-walled room rather than dirt on piers, basement mold removal is the right scope. Where the growth is a dark slimy colony on saturated wood or drywall paper, see black mold removal. Before work begins, mold inspection and testing maps the moisture extent; afterwards, independent mold clearance testing verifies it.

Technician insight

The crawl space jobs that come back are the ones where somebody cleaned the joists and left the dirt exposed. In Caddo Parish the soil is the reservoir — it will hold moisture through a mild winter and start feeding the floor framing again by May. If the quote you are holding lists cleaning and antimicrobial but no vapor barrier, no drainage work and no humidity control, you are buying one season.

Crawl Space Mold Removal Services We Offer

✓Crawl Space Mold Inspection and Moisture Mapping

Soil, joist and subfloor moisture readings across the full footprint to locate the source before any removal begins, since cleaning without correcting moisture guarantees recurrence in Caddo Parish.

✓Contaminated Insulation Removal

Removal and bagging of moisture-saturated fiberglass batt insulation, which rarely survives a crawl space mold event and holds spores long after the framing is cleaned.

✓Joist and Subfloor Cleaning

HEPA vacuuming and controlled surface cleaning of framing where growth has penetrated the wood, followed by antimicrobial application rather than in place of removal.

✓Vapor Barrier Installation

Sealed barrier across exposed soil with seams lapped and taped and the perimeter detailed — the single highest-value correction in a Shreveport pier-and-beam crawl space.

✓Crawl Space Encapsulation

Full sealing of the crawl space including vents, with a dedicated dehumidifier holding relative humidity under 60% so the space stops condensing on the joists each summer.

✓Drainage and Grading Correction

Perimeter work to stop surface water running toward the foundation on the flat terrain typical of Shreveport lots, addressing the water before it reaches the soil beneath the house.

✓Structural Damage Assessment

Documentation of soft sill plates, joist end decay and subfloor delamination found during remediation, quoted separately as carpentry so there are no surprises mid-project.

Crawl Space Mold Removal Cost in Shreveport, LA

Service Typical Range What Affects It
Crawl Space Mold Removal — Limited Area $500–$1,200 Localized growth under one or two rooms, access adequate
Crawl Space Mold Removal — Full Footprint $1,200–$2,500 Whole crawl space, includes insulation removal and disposal
Vapor Barrier Replacement $0.50–$1.50 / sq ft Sealed 10-20 mil barrier across exposed soil
Full Crawl Space Encapsulation $3,000–$7,000 Barrier, vent sealing, perimeter detailing and dehumidifier
Crawl Space Dehumidifier — Supplied and Set $1,200–$2,400 Sized to footprint, condensate routed to exterior
Joist or Subfloor Repair Quoted separately Carpentry where sustained moisture caused decay

Ranges are typical for Shreveport, LA and confirmed with an exact written quote before any work starts.

How it works

  1. 1

    Crawl Space Entry and Assessment

    Enter and document the full footprint: extent of growth, moisture readings on soil and framing, standing water, vapor barrier condition, and any visible structural decay.

  2. 2

    Identify the Water Source

    Trace whether the moisture is groundwater, surface drainage, a plumbing leak, or condensation from humid air entering through vents. The source determines the correction.

  3. 3

    Containment and Negative Air

    Seal the crawl space access and run HEPA filtration so removal work does not push spores up into the living space through the floor.

  4. 4

    Remove Contaminated Material

    Bag and remove saturated insulation, debris and any porous material that cannot be cleaned, then HEPA vacuum the framing and subfloor.

  5. 5

    Clean and Treat Framing

    Controlled cleaning of joists, piers and subfloor where growth penetrated the wood surface, followed by an EPA-registered antimicrobial after physical removal is complete.

  6. 6

    Correct the Moisture

    Install a sealed vapor barrier, address drainage and grading, seal vents where encapsulating, and set a dehumidifier sized to hold the space under 60% relative humidity.

  7. 7

    Document and Verify

    Deliver photographs, moisture readings and a written scope of what was done, with referral to an independent assessor if clearance testing is required.

Pricing

Most Shreveport crawl space mold removal runs $500 to $2,500. Full encapsulation — sealed vapor barrier, vent sealing and a dehumidifier — typically brings the total to $3,000 to $7,000, which is what stops recurrence here.

Good to know

Crawl Space Mold Removal — FAQs

Still have questions? We're happy to talk it through.

(318) 858-4231
+ How much does crawl space mold removal cost in Shreveport?
Most Shreveport crawl space mold removal projects run $500 to $2,500 depending on footprint and access. Adding full encapsulation with a sealed vapor barrier, vent sealing and a dehumidifier typically brings the total to $3,000 to $7,000. National per-square-foot rates for crawl space work including encapsulation run roughly $7 to $15.
+ Why does crawl space mold keep coming back after cleaning?
Because cleaning removes the colony, not the condition. In Shreveport the soil under a pier-and-beam home holds moisture year-round and the humid air entering through the vents condenses on cooler joists each summer. Until the soil is covered with a sealed barrier and the humidity is controlled, the framing stays wet enough to regrow.
+ Does crawl space mold affect the air inside my house?
Yes. Roughly half the air on a home's first floor has passed through the crawl space, drawn upward by the stack effect. A musty smell strongest in the morning, cupping hardwood floors, and allergy symptoms that ease when the family is away from the house are all common signs of a crawl space source.
+ Should I encapsulate my crawl space or just add vents?
In Shreveport's climate, venting works against you. On a humid summer afternoon a vent brings in air near saturation that condenses on crawl space framing sitting twenty degrees cooler. Sealing and dehumidifying is the approach suited to a humid subtropical climate; open venting suits dry climates.
+ Do you remove the insulation, or can it be cleaned?
Moisture-saturated fiberglass batt insulation is removed and replaced. It is porous, it holds spores after the framing is cleaned, and it loses most of its R-value once wet. Attempting to clean it in place is one of the more common reasons a crawl space fails clearance testing.
+ What if you find rotted joists or a damaged subfloor?
You get it documented with photographs and moisture readings, and quoted separately as carpentry. Sustained crawl space moisture in older Shreveport homes frequently causes soft sill plates and joist end decay, and it is better to know the scope before work starts than halfway through.
+ How long does crawl space mold removal take?
A limited-area removal is usually one day. A full-footprint removal with insulation disposal typically takes two to three days, and adding full encapsulation extends it to three to five depending on crawl space height and access.

Need Mold Removal in Shreveport, LA?

Talk to a local Shreveport mold removal and remediation crew serving Shreveport and nearby neighborhoods. Every mold removal project starts with a written scope naming the contaminated area, what gets removed versus cleaned, and who corrects the water source — with published price ranges you can compare before you call.

Business hours

Mon–Sat 7:00 AM – 7:00 PM

5782 St Vincent Ave, Shreveport, LA 71108

Call now Get a quote